This article mainly introduces:

Qatar hydraulic cylinder,push and pull the cylinder manufacturer,push and pull the cylinder

(Qatar push and pull the cylinder,produced by Hengyu Hydraulic Co., Ltd）

push and pull the cylinder are widely used in Qatar，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed push and pull the cylinder for customers from Qatar.

Introduction to push and pull the cylinder:

In the case of serious wear on the inner surface of the push and pull the cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the push and pull the cylinder manufacturing process for replacement. The push and pull the cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

In order to ensure the service life of the push and pull the cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the push and pull the cylinder, causing damage to the seal and causing leakage in the push and pull the cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

push and pull the cylinder installation precautions: Before installing the push and pull the cylinder into the system, the parameters on the push and pull the cylinder label should be compared with the parameters when ordering. The base of the push and pull the cylinder must have sufficient stiffness, otherwise the push and pull the cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

In the process of using the push and pull the cylinder, sometimes such a problem will occur, the push and pull the cylinder can not act immediately after the instruction of the push and pull the cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil push and pull the cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

Answers to some questions about push and pull the cylinder:

How is the hydraulic cylinder selected in the mechanical design manual?
First of all, it is necessary to meet your work needs, and the second is to meet the structural space of the cylinder and accessories. Three to consider the other parameters of the cylinder.

What are the reasons why the hydraulic cylinder action is slower than normal?
There are many factors that cause this problem. First, measure the pressure of the main system to see whether the pressure of the main system under the pressure state is consistent with the initial setting. Before measuring the pressure, it is best to check the hydraulic oil and suction oil filter and replace or clean it. Second, check the main relief valve of the reversing control multiway valve to see if there is damage or foreign matter blocking, and clean it. If your pump is a gear pump, the problem should generally be small. Second, look at traffic. There is no leakage in the cylinder, leakage in the reversing valve spool and so on.