This article mainly introduces:

Turkmenistan hydraulic cylinder,tailboard balance cylinder manufacturer,tailboard balance cylinder

(Turkmenistan tailboard balance cylinder,produced by Hengyu Group）

tailboard balance cylinder are widely used in Turkmenistan，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed tailboard balance cylinder for customers from Turkmenistan.

Introduction to tailboard balance cylinder:

The piston rod and guide sleeve function of the tailboard balance cylinder is crucial: the relative motion pair between the piston rod and the guide sleeve is the main factor causing external leakage, if the chrome layer on the surface of the piston rod is spalling or producing longitudinal tensile marks due to wear, it will directly lead to the failure of the seal.

When the control pressure of the hydraulic system is too low, the tailboard balance cylinder will appear wrong or no action, because the throttle resistance in the control pipeline may be too large, the flow valve is improperly adjusted, the control pressure is inappropriate, and the pressure source is interfered with. At this time, check the control pressure source to ensure that the pressure is adjusted to the specified value of the system.

When the tailboard balance cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the tailboard balance cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

The wear of the hard chromium plating layer of the tailboard balance cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

Answers to some questions about tailboard balance cylinder:

How big gear pump need to use for 60*100 cylinder?
One cylinder size alone does not determine the size of the pump used. Choose the size of the pump, at least to know 1, the size of the load is how much, by the size of the load and the size of the cylinder and other conditions can be calculated the pressure required by the hydraulic system. 2. Speed of operation. From this speed and cylinder size, the required flow rate of the system is calculated. The relevant parameters of the pump can be selected by the pressure and flow rate to determine what kind of pump is required.

How to distinguish the size of hydraulic cylinder cavity?
The hydraulic cylinder has a rod cavity and a rodless cavity. The rod cavity is the cavity that the piston rod extends out. The rod cavity is of course small due to the existence of the piston rod. That's just relative.