This article mainly introduces:

Tanzania hydraulic cylinder,sanitation truck hydraulic cylinder manufacturer,sanitation truck hydraulic cylinder

(Tanzania sanitation truck hydraulic cylinder,produced by Hengyu Group）

sanitation truck hydraulic cylinder are widely used in Tanzania，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed sanitation truck hydraulic cylinder for customers from Tanzania.

Introduction to sanitation truck hydraulic cylinder:

When the sanitation truck hydraulic cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the sanitation truck hydraulic cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

The sanitation truck hydraulic cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the sanitation truck hydraulic cylinder, bite. Elimination method: When installing the sanitation truck hydraulic cylinder, ensure that the axis position of the sanitation truck hydraulic cylinder is consistent with the direction of movement; Make the load borne by the sanitation truck hydraulic cylinder as far as possible through the sanitation truck hydraulic cylinder axis, to avoid the phenomenon of eccentricity.

sanitation truck hydraulic cylinder body inspection: The inner surface of the sanitation truck hydraulic cylinder and the piston seal are the main factors causing the leakage in the sanitation truck hydraulic cylinder, if the sanitation truck hydraulic cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the sanitation truck hydraulic cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

Repair method of small range wear of oil sanitation truck hydraulic cylinder: 1. Use oxygen-acetylene flame to bake the scratched part (master the temperature, avoid surface annealing), bake the oil on the metal surface all the year round until no sparks splash; 2. The scratched part is treated with an Angle grinder, the grinding depth is more than 1 mm, and the groove is polished along the guide rail, preferably a dovetail groove. Scratch both ends of the drilling deeper, change the force situation; 3. Clean the surface with absorbent cotton dipped in acetone or anhydrous ethanol.

Answers to some questions about sanitation truck hydraulic cylinder:

How to disassemble the big nut that excavate the oil cylinder piston of the excavator?
If you want to be safe, look for a special unloading place for this thing, which is an oil cylinder on top of a turntable with a large nut attached to the center of the turntable. If you're in the field just pin the head of the cylinder to one end, use a big homemade wrench to hold the nut in place, and then get a digging machine and push it down, and it opens.

What is a hydraulic cylinder assembly?
Assembly, which means aggregate. A series of parts or products, formed to achieve a specific function of the whole, the general term for this system is assembly. The hydraulic cylinder assembly is not a single hydraulic cylinder part, which can be used by connecting the hydraulic hose.