This article mainly introduces:

Libya hydraulic cylinder,fig support cylinder manufacturer,fig support cylinder

(Libya fig support cylinder,produced by Hengyu Hydraulic Co., Ltd）

fig support cylinder are widely used in Libya，because of no need for deceleration device，long service life，smooth movement.So our company has designed fig support cylinder for customers from Libya.

Introduction to fig support cylinder:

In the case of serious wear on the inner surface of the fig support cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the fig support cylinder manufacturing process for replacement. The fig support cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

In order to ensure the service life of the fig support cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the fig support cylinder, causing damage to the seal and causing leakage in the fig support cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

When the fig support cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the fig support cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil fig support cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical fig support cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the fig support cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

Most of the failure of the fig support cylinder is because there is a foreign body in the fig support cylinder into the failure of the fig support cylinder, the most problematic is that it is difficult to determine when the foreign body is into the fig support cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

Answers to some questions about fig support cylinder:

What are the problems that cause hydraulic cylinder shaking?
1, the oil supply is not smooth, the hydraulic oil filter is half blocked. 2. The oil level in the oil storage tank is lower than the minimum oil level. 3, there is air in the hydraulic system. 4, the supply oil pump is damaged or not working properly. 5, the hydraulic oil is not replaced for a long time.

Where's the hydraulic cylinder bleed valve?
There is a vent hole at the top of the cylinder next to the intake pipe. Generally, it can be used, and the air in the cylinder can be naturally drained after several moves.