This article mainly introduces:

Britain hydraulic cylinder,servo hydraulic cylinder manufacturer,servo hydraulic cylinder

(Britain servo hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

servo hydraulic cylinder are widely used in Britain，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed servo hydraulic cylinder for customers from Britain.

Introduction to servo hydraulic cylinder:

servo hydraulic cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards servo hydraulic cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the servo hydraulic cylinder guide is determined by the length of the stroke. Check the strength of servo hydraulic cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

The servo hydraulic cylinder should be vented: when the servo hydraulic cylinder is installed or parked for a long time to work again, the air will penetrate into the servo hydraulic cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the servo hydraulic cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the servo hydraulic cylinder, the oil is best entered and discharged from the highest point of the servo hydraulic cylinder. servo hydraulic cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

The material of the sliding part of the servo hydraulic cylinder piston sintered casting piston will cause sintering phenomenon when subjected to large transverse load. In this case, the sliding part of the piston should be made of copper alloy or welded to such material.

There are some honeycomb holes in the inner wall of the servo hydraulic cylinder, piston or piston rod surface. How is this formed? When we repair the servo hydraulic cylinder, we can see that there are some honeycomb holes on the inner wall of the servo hydraulic cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the servo hydraulic cylinder is targeted to prevent. Is very necessary.

Answers to some questions about servo hydraulic cylinder:

What are the main dimensions of the cylinder?
The main dimensions of the cylinder include: cylinder inner diameter, piston cylinder diameter, cylinder length, cylinder wall thickness, stroke, installation distance, etc.

What is the material of the hydraulic cylinder slider?
Three parts of the hydraulic cylinder are essential, which are: cylinder - cylinder head assembly, piston - piston rod assembly, and sealing device. When you say slider, you mean piston. - Piston rod. Piston materials commonly used gray cast iron, wear-resistant cast iron, aluminum alloy (assembled), etc., can also be used 35 and 45 steel (integral). The piston rod is generally made of 35 and 45 steel. When the impact vibration is large, alloy steel such as 55 steel or 40Cr is used.