This article mainly introduces:

S.Africa hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(S.Africa steel mill cylinder,produced by Hengyu Group）

steel mill cylinder are widely used in S.Africa，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed steel mill cylinder for customers from S.Africa.

Introduction to steel mill cylinder:

When the steel mill cylinder is in use, ensure that the steel mill cylinder and the surrounding environment should be clean. The tank should be sealed to prevent contamination. Pipelines and fuel tanks should be cleaned to prevent falling off the oxide sheet and other debris. Clean with lint-free cloth or special paper. Twine and binder should not be used as sealing materials. Hydraulic oil according to the design requirements, pay attention to the change of oil temperature and oil pressure. When there is no load, unscrew the exhaust bolt for exhaust.

In the case of serious wear on the inner surface of the steel mill cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the steel mill cylinder manufacturing process for replacement. The steel mill cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

The steel mill cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the steel mill cylinder, bite. Elimination method: When installing the steel mill cylinder, ensure that the axis position of the steel mill cylinder is consistent with the direction of movement; Make the load borne by the steel mill cylinder as far as possible through the steel mill cylinder axis, to avoid the phenomenon of eccentricity.

When the steel mill cylinder is installed, the piston and the steel mill cylinder head and other parts have large mass, large size and large inertia, even if there is a lifting equipment auxiliary installation, because the specified clearance is small, no matter how hard it will be put into, therefore, the end of the piston or the steel mill cylinder head boss is easy to cause scars when it hits the inner surface of the steel mill cylinder wall. The solution to this problem: for a large number of small products, the use of autocratic assembly oriented tools during installation; For heavy, thick and large large and medium-sized steel mill cylinders, only careful and careful operation can be avoided.

Answers to some questions about steel mill cylinder:

What does cylinder speed ratio mean?
The speed ratio of the cylinder is the ratio of the reciprocating speed of the piston, equal to the ratio of the rodless cavity area to the roded cavity area.

How to make 4 cylinders balance lifting weight at the same time?
The cost of the synchronous valve is lower, 4 cylinders need 3 synchronous valves, to be precise you can use a synchronous motor, but it is more expensive. There is another way, that is to install a throttle valve in each cylinder, respectively adjust the speed of the cylinder.