This article mainly introduces:

Tunisia hydraulic cylinder,synchronous hydraulic cylinder manufacturer,synchronous hydraulic cylinder

(Tunisia synchronous hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

synchronous hydraulic cylinder are widely used in Tunisia，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed synchronous hydraulic cylinder for customers from Tunisia.

Introduction to synchronous hydraulic cylinder:

The synchronous hydraulic cylinder should be used correctly and maintained regularly. The synchronous hydraulic cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the synchronous hydraulic cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

Do not enter foreign bodies when installing the synchronous hydraulic cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

synchronous hydraulic cylinder use should try to avoid sealing belt into the synchronous hydraulic cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the synchronous hydraulic cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the synchronous hydraulic cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

Factors that should be considered when selecting the oil seal in the synchronous hydraulic cylinder: some specific factors should be taken into account when selecting the oil seal in the synchronous hydraulic cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: synchronous hydraulic cylinder diameter, piston rod diameter, piston rod and piston groove size, synchronous hydraulic cylinder working pressure, synchronous hydraulic cylinder movement speed, hydraulic system oil temperature and synchronous hydraulic cylinder working environment.

Answers to some questions about synchronous hydraulic cylinder:

What is the rated pressure of the general cylinder?
This depends on the model of the cylinder, 1. The rated pressure of the light tie rod cylinder is 7 series 7MPa and 14 series 14MPa. 2. Rated pressure of engineering cylinder 16MPa. 3. Rexroth type metallurgical cylinder rated pressure 250MPa.

What material should be selected to seal the cylinder?
The choice of material for sealing is related to the working environment, strength, and medium of your equipment.