This article mainly introduces:

Turkmenistan hydraulic cylinder,pushing cylinder manufacturer,pushing cylinder

(Turkmenistan pushing cylinder,produced by Hengyu Hydraulic Cylinder Factory）

pushing cylinder are widely used in Turkmenistan，because of long service life，smooth movement，high work efficiency.So our company has designed pushing cylinder for customers from Turkmenistan.

Introduction to pushing cylinder:

Classification of pushing cylinder: according to the mode of movement it can be divided into linear reciprocating movement type and rotary swing type; According to the effect of liquid pressure, it can be divided into single acting type and double acting type. According to the structure, it can be divided into piston type, plunger type, multistage telescopic sleeve type, pinion and rack type, etc. According to the installation form can be divided into rod, earring, foot, hinge shaft and so on; According to the pressure grade can be divided into 16Mpa, 25Mpa, 31.5Mpa and so on.

In use, the pushing cylinder should try to avoid the friction iron powder or iron filings formed by buffering the plunger. When the matching gap of the buffer device is small and the transverse load on the piston rod is large, the sintering phenomenon may be caused. These friction iron powder or the metal fragments that have fallen off as a result of sintering will remain in the pushing cylinder.

pushing cylinder can not drive the load troubleshooting: oil pressure is too low. pushing cylinder selection specifications are too small. Leakage in pushing cylinder or associated hydraulic system element.

If it is found that the pushing cylinder lubrication is poor or the pushing cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the pushing cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the pushing cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the pushing cylinder center line. In this way, when the piston works in the pushing cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the pushing cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

Answers to some questions about pushing cylinder:

What valve is used to control cylinder expansion?
Mainly use reversing valve, but the details of the control need hydraulic control valve, hydraulic control valve can be divided into direction control valve, pressure control valve, flow control valve. The valve controls the expansion of the cylinder is the direction control valve, that is, the reversing valve. What is the meaning of two-position three-way and three-position four-way of the reversing valve? Usually according to the different working positions that can stay after the spool is moved, it can be divided into: two-position valves, three-position valves and multi-position valves. According to the number of different slide valve channels can be divided into: two-way valve, three-way valve, four-way valve, five-way valve and multi-way valve. The name of the reversing valve is called the multi-position and multi-pass reversing valve according to its working position and the number of channels.

What is hydraulic cylinder guide?
The cylinder itself can not move, the piston moves, the guide should be used to guide the mechanism connected with the piston extension end. For example, in the commonly used hydraulic press, the guide column above is used to guide the pressure plate connected with the piston.