This article mainly introduces:

Nigeria hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Nigeria steering power cylinder,produced by Hengyu Group）

steering power cylinder are widely used in Nigeria，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed steering power cylinder for customers from Nigeria.

Introduction to steering power cylinder:

The material, shape and compression of the steering power cylinder seal have a great impact on the service life and work efficiency of the steering power cylinder. In addition to requiring a reliable seal, it should also have a long service life and less friction loss. At present, there are many seal manufacturers in the country, and it is also crucial to choose high-quality seals with reliable and stable quality.

The steering power cylinder should be avoided for a long time without use, if it is indeed idle for a long time for some reason, it should also be regularly turned on for empty operation, so that its parts can be fully lubricated, so as to avoid rust on the working surface and affect the normal work in the future. (If it cannot be turned on and run, a small amount of lubricating oil can be applied on its outer surface for protection) ' The use of the steering power cylinder should pay attention to: the operation should be as far away from the steering power cylinder as possible, to avoid falling objects, knocking, rubbing the steering power cylinder coating. When cleaning the steering power cylinder, only use soft materials (such as cotton) to wipe, and do not scratch high-hardness materials. Do not use the steering power cylinder when the oil temperature exceeds 70 ° C.

steering power cylinder use should try to avoid sealing belt into the steering power cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the steering power cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the steering power cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

The steering power cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the steering power cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the steering power cylinder wall due to the stiffness and the weight of the parts, causing scars.

Answers to some questions about steering power cylinder:

Can a leak in the cylinder cause the hydraulic system to fail?
Leakage in the cylinder can cause the hydraulic system to fail. Cylinder leakage (internal leakage) first affects the controlled action of the hydraulic system can not meet the requirements (such as the movement speed of the cylinder, the insufficient thrust and tension of the cylinder), if the internal leakage of the cylinder is too large, it may also cause the cylinder to be unable to promote the load movement. Second, the existence of internal leakage (internal leakage) of the oil cylinder will lead to the rapid rise (or too high) of the oil temperature of the hydraulic system, and the high oil temperature will not only waste the energy conversion of the system, but also lead to the reduction of the viscosity of the oil, which will accelerate the aging and destruction of the seals such as pumps, valves, cylinders, pipelines, and at the same time, the lubrication effect of the hydraulic oil is reduced, and the production of iron filings that increase the friction of the hydraulic system.

What steel pipe does hydraulic cylinder use? This problem is very general. Carbon steel pipe or ordinary seamless steel pipe are all ok, but then there are rolling, quilting, heat treatment and other steps, and the requirements are different, the wall thickness is different, the material is different. It depends on the circumstances.