This article mainly introduces:

Uruguay hydraulic cylinder,tailplate hydraulic cylinder manufacturer,tailplate hydraulic cylinder

(Uruguay tailplate hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

tailplate hydraulic cylinder are widely used in Uruguay，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed tailplate hydraulic cylinder for customers from Uruguay.

Introduction to tailplate hydraulic cylinder:

tailplate hydraulic cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards tailplate hydraulic cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the tailplate hydraulic cylinder guide is determined by the length of the stroke. Check the strength of tailplate hydraulic cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

The tailplate hydraulic cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the tailplate hydraulic cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the tailplate hydraulic cylinder wall due to the stiffness and the weight of the parts, causing scars.

If air enters the hydraulic system, the tailplate hydraulic cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

Protection of the tailplate hydraulic cylinder surface: During the dismantling process, safety protection should be carried out on the tailplate hydraulic cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the tailplate hydraulic cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the tailplate hydraulic cylinder should be cleaned up in time.

Answers to some questions about tailplate hydraulic cylinder:

What factors does the movement speed of the cylinder in the hydraulic system depend on?
The hydraulic system should be the piston movement in the cylinder, and the speed should also be the speed of the piston, according to the piston speed formula: v=4qm/pai*(D^2-d^2) where q is the flow rate of the input hydraulic cylinder, m is the volumetric efficiency of the hydraulic cylinder, D, d is the diameter of the piston and piston rod, because other factors are determined, the movement speed of the cylinder depends on the flow rate.

How to remove the air in hydraulic cylinder?
Connected the cylinder to the system, and reciprocating move with full stroke several times, then the air can be eliminated . There is also a clunky method as follows: first remove the rod cavity oil pipe, connect the rodless cavity oil circuit to extend all the cylinders, and then remove the rodless cavity oil pipe, connect the rod cavity oil pipe and withdraw all the cylinders, and then connect the rodless cavity oil pipe, so that there is no air in the cylinder.