This article mainly introduces:

Panama hydraulic cylinder,supporting cylinder manufacturer,supporting cylinder

(Panama supporting cylinder,produced by Hengyu Hydraulic Co., Ltd）

supporting cylinder are widely used in Panama，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed supporting cylinder for customers from Panama.

Introduction to supporting cylinder:

supporting cylinder buffer valve inspection and maintenance: For the valve buffer supporting cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

The piston rod and guide sleeve function of the supporting cylinder is crucial: the relative motion pair between the piston rod and the guide sleeve is the main factor causing external leakage, if the chrome layer on the surface of the piston rod is spalling or producing longitudinal tensile marks due to wear, it will directly lead to the failure of the seal.

Do not regularly check the damage of the chrome layer of the supporting cylinder: completely extend the supporting cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the supporting cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the supporting cylinder seal. Welding slag is strictly prohibited on the surface of the supporting cylinder.

When producing oil supporting cylinders, there are two processing processes, grinding and rolling, the latter is better than the former. Rolling machining is a kind of non-cutting machining, using the plastic deformation of the metal at room temperature, so that the micro roughness of the workpiece surface is flattened to achieve the purpose of changing the surface structure, mechanical characteristics, shape and size. Therefore, this method can achieve the two purposes of finishing and strengthening at the same time, which can not be done by grinding.

Answers to some questions about supporting cylinder:

What diameter cylinder is needed for a force of 5 tons?
It depends on the pressure of your system pump. If the normal working pressure of the system is about 8MPa, then the diameter of the cylinder should be 100 mm.

How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).