This article mainly introduces:

Sudan hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Sudan steering power cylinder,produced by Hengyu Hydraulic Cylinder Factory）

steering power cylinder are widely used in Sudan，because of excellent fatigue and impact resistance，excellent temperature resistance，simple structure and reliable operation.So our company has designed steering power cylinder for customers from Sudan.

Introduction to steering power cylinder:

If the steering power cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

The oil steering power cylinder is a part of the hydraulic system, in the hydraulic system, to reasonably design the heat dissipation system, to prevent the oil temperature is too high is the key to keep the hydraulic oil temperature normal. The temperature of the system should be kept in a suitable range to reduce the energy released when the bubble bursts. While not affecting the normal circulation of the coolant, a certain amount of anti-corrosion additives can be appropriately added to inhibit rust. When operating the hydraulic system, we should strive to be stable, not too fast, too strong, and try to reduce the impact of hydraulic oil on hydraulic components.

The steering power cylinder is mainly composed of body, piston, piston rod, steering power cylinder head, steering power cylinder bottom, piston rod head and related auxiliary devices. The piston divides the steering power cylinder into two chambers, and moves reciprocally in the steering power cylinder with the help of pressure oil. In order to improve its working effect, there is no sealing ring on the piston to eliminate internal leakage, where the piston rod passes through the steering power cylinder head, due to the existence of the gap, it is easy to produce external leakage phenomenon, and the dust can enter the steering power cylinder through the gap, so the sealing device and dust prevention reason are set. At the same time, in order to eliminate the influence of eccentric load on the work of the piston, all the steering power cylinders must be provided with a considerable length of guide sleeve at the extended end of the piston rod. In addition, in the case of faster piston movement, the phenomenon of mechanical collision between the piston and the steering power cylinder bottom and the steering power cylinder head is serious, so the buffer deceleration should be set at both ends of the steering power cylinder The working medium of the steering power cylinder: because it works at room temperature, the ordinary oil-type hydraulic oil can be selected; steering power cylinder sealing device: The use of Yx sealing ring, polyurethane (PU) and polytetrafluoroethylene (PTFE) materials combined to achieve a good sealing effect; Buffer mechanism of the steering power cylinder: The buffer structure of the steering power cylinder is to prevent the piston from colliding with the steering power cylinder head at the end of the stroke.

steering power cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the steering power cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the steering power cylinder. c. The steering power cylinder seal is extruded, if the O-ring is obviously extruded at the steering power cylinder seal, replace the steering power cylinder seal.

Answers to some questions about steering power cylinder:

What material should be selected to seal the cylinder?
The choice of material for sealing is related to the working environment, strength, and medium of your equipment.

What is the pressure provided for a 63-bore cylinder with a pressure of 2 mpa?
2 mpa pressure is equivalent to 20 kg per square centimeter, 6.3 cm straight longitude, 3.15 cm radius, square, multiplied by, calculated an area of about 31.5 square centimeters, multiplied by 20 kg, the pressure is about 630 kg.