This article mainly introduces:

Guatemala hydraulic cylinder,loading cylinder manufacturer,loading cylinder

(Guatemala loading cylinder,produced by Hengyu Group）

loading cylinder are widely used in Guatemala，because of simple structure and reliable operation，no transmission clearance，excellent temperature resistance.So our company has designed loading cylinder for customers from Guatemala.

Introduction to loading cylinder:

loading cylinder body inspection: The inner surface of the loading cylinder and the piston seal are the main factors causing the leakage in the loading cylinder, if the loading cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the loading cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

loading cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards loading cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the loading cylinder guide is determined by the length of the stroke. Check the strength of loading cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

loading cylinder hydraulic oil selection: The recommended working oil viscosity of the loading cylinder is 10 ~ 110cSt (1.8 ~ 15E), ISO VG46 hydraulic oil. The normal working oil temperature is 10 ~ 70℃, and the ambient temperature is in the range of -20 ~ 80℃. When the ambient temperature and service temperature are low, the hydraulic oil with lower viscosity can be selected.

At the rated pressure, the thrust of the loading cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the loading cylinder is related to the diameter of the loading cylinder, but not to the stroke of the loading cylinder. Moreover, the larger the loading cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the loading cylinder.

Answers to some questions about loading cylinder:

How to repair the bent oil cylinder correctly?
If the bending oil cylinder leaks, the most direct way is to replace the seal ring. Most of the sealing rings used by domestic bending machines are made in Taiwan and Japan, so the service life of the sealing ring is still relatively long. If the bending oil cylinder used by the customer leaks oil, then when replacing the seal ring, be sure to choose a high-quality and durable seal ring. In this way, the replaced cylinder will not leak oil for a long time.

What diameter cylinder is needed for a force of 5 tons?
It depends on the pressure of your system pump. If the normal working pressure of the system is about 8MPa, then the diameter of the cylinder should be 100 mm.