This article mainly introduces:

Azerbaijan hydraulic cylinder,hydraulic support cylinder manufacturer,hydraulic support cylinder

(Azerbaijan hydraulic support cylinder,produced by Hengyu Hydraulic Cylinder Factory）

hydraulic support cylinder are widely used in Azerbaijan，because of no need for deceleration device，long service life，smooth movement.So our company has designed hydraulic support cylinder for customers from Azerbaijan.

Introduction to hydraulic support cylinder:

The hydraulic support cylinder should be vented: when the hydraulic support cylinder is installed or parked for a long time to work again, the air will penetrate into the hydraulic support cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the hydraulic support cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the hydraulic support cylinder, the oil is best entered and discharged from the highest point of the hydraulic support cylinder. hydraulic support cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

We can not just consider the price and ignore the quality when we purchase the hydraulic support cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the hydraulic support cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the hydraulic support cylinder is not required.

At the rated pressure, the thrust of the hydraulic support cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the hydraulic support cylinder is related to the diameter of the hydraulic support cylinder, but not to the stroke of the hydraulic support cylinder. Moreover, the larger the hydraulic support cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the hydraulic support cylinder.

Do not regularly check the damage of the chrome layer of the hydraulic support cylinder: completely extend the hydraulic support cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the hydraulic support cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the hydraulic support cylinder seal. Welding slag is strictly prohibited on the surface of the hydraulic support cylinder.

Answers to some questions about hydraulic support cylinder:

Does the excavator use a hydraulic cylinder?
First, construction machinery is generally a hydraulic cylinder. Second, hydraulic transmission equipment is usually composed of four components, power, execution, control and auxiliary. And the hydraulic cylinder as a linear reciprocating motion or less than 360. Reciprocating motion of the hydraulic mechanism, simple structure, reliable work, is also widely used in the hydraulic system of the main actuator, it is the prime mover in the form of mechanical energy to drive the hydraulic pump produced by the liquid pressure energy, and then can be directly driven load for reciprocating movement or less than 360.

What hydraulic oil does servo cylinder generally use?
The medium used by the cylinder generally depends on the working condition of the use, including pressure, installation environment, sealing material, etc. I think the first thing to consider is the impact of the sealing material. Mineral oil is a good choice if it is not too fire-resistant or used in a high temperature environment. 1, servo cylinder features: closed-loop servo control, control accuracy of 0.01mm; Precise control of thrust, increase pressure sensor, control accuracy up to 1%; It is easy to connect with PLC and other control systems to achieve high precision motion control. Low noise, energy saving, clean, high rigidity, impact resistance, long life, simple operation and maintenance. 2, the servo cylinder can be fault-free in harsh environments, and the protection level can reach IP66.