This article mainly introduces:

Kuwait hydraulic cylinder,steering cylinder manufacturer,steering cylinder

(Kuwait steering cylinder,produced by Hengyu Hydraulic Cylinder Factory）

steering cylinder are widely used in Kuwait，because of clever hydraulic energy conversion，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed steering cylinder for customers from Kuwait.

Introduction to steering cylinder:

The body of the steering cylinder on the processing process requirements: the body of the steering cylinder is an important and essential part of the steering cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the steering cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

Regular maintenance of the steering cylinder includes: regular tightening, steering cylinder fastening screws and gland screws, steering cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the steering cylinder once a year. Clean regularly, the steering cylinder is cleaned every other year, and the seals are replaced while cleaning.

The scar on the sliding surface of the steering cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the steering cylinder wall. Therefore, before installation, these scars must be fully repaired.

The internal leakage of the steering cylinder is an important indicator to measure the quality of the steering cylinder: the internal leakage of the steering cylinder will reduce the volumetric efficiency, increase the temperature rise of the oil, affect the positioning accuracy of the steering cylinder, so that the steering cylinder can not accurately and stably stop in a certain position of the steering cylinder, so it is one of the main indicators of the steering cylinder.

Answers to some questions about steering cylinder:

What is the material of the hydraulic cylinder slider?
Three parts of the hydraulic cylinder are essential, which are: cylinder - cylinder head assembly, piston - piston rod assembly, and sealing device. When you say slider, you mean piston. - Piston rod. Piston materials commonly used gray cast iron, wear-resistant cast iron, aluminum alloy (assembled), etc., can also be used 35 and 45 steel (integral). The piston rod is generally made of 35 and 45 steel. When the impact vibration is large, alloy steel such as 55 steel or 40Cr is used.

What is a constant velocity cylinder? What is the difference between hydraulic cylinder and constant velocity cylinder?
The constant speed cylinder should be the same as the speed of the piston rod extension and withdrawal cylinder is called the constant speed cylinder. The difference between it and the ordinary hydraulic cylinder is that the ordinary hydraulic cylinder only has a piston rod extended out, and the general extension speed is slow and the recovery speed is fast, because of the relationship between the effective area. Effective area of piston chamber > Effective area of piston rod chamber. The effective area on both sides of the constant speed cylinder is the same, because there are piston rods sticking out at both ends. The application of constant speed cylinder is most common in grinding machines.