This article mainly introduces:

Oman hydraulic cylinder,stroke adjustable cylinder manufacturer,stroke adjustable cylinder

(Oman stroke adjustable cylinder,produced by Hengyu Group）

stroke adjustable cylinder are widely used in Oman，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed stroke adjustable cylinder for customers from Oman.

Introduction to stroke adjustable cylinder:

Before the stroke adjustable cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

stroke adjustable cylinder piston sealing is best to use Yx ring, polyurethane and polytetrafluoroethylene sealing material combination, can significantly improve the sealing performance: (I), reduce friction resistance, no crawling phenomenon; (ii) Have good dynamic and static sealing, wear resistance, long service life; (iii) The installation groove is simple, and the disassembly is simple.

The definition of the minimum starting pressure of the stroke adjustable cylinder refers to the minimum working pressure of the stroke adjustable cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the stroke adjustable cylinder parts and the size of the sealing friction.

When installing the stroke adjustable cylinder pipe, the pipe should be cleaned after installation, and should not pass through the stroke adjustable cylinder block, and the by-pass pipe must be installed in front of the oil port of the stroke adjustable cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the stroke adjustable cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the stroke adjustable cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

Answers to some questions about stroke adjustable cylinder:

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.

Injection molding machine die thimble on the side of the feed nozzle, the oil cylinder pull the thimble shift, how to debug the oil cylinder?
The cylinder is connected with the neutron of the injection molding machine, the neutron is retreated after the opening mold is in place, the cylinder taps the thimble plate to the top, and then takes, and the neutron is reset.