This article mainly introduces:

Turkmenistan hydraulic cylinder,hydraulic jig cylinder manufacturer,hydraulic jig cylinder

(Turkmenistan hydraulic jig cylinder,produced by Hengyu Hydraulic Co., Ltd）

hydraulic jig cylinder are widely used in Turkmenistan，because of long service life，smooth movement，high work efficiency.So our company has designed hydraulic jig cylinder for customers from Turkmenistan.

Introduction to hydraulic jig cylinder:

The scar on the sliding surface of the hydraulic jig cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the hydraulic jig cylinder wall. Therefore, before installation, these scars must be fully repaired.

hydraulic jig cylinder installation precautions: Before installing the hydraulic jig cylinder into the system, the parameters on the hydraulic jig cylinder label should be compared with the parameters when ordering. The base of the hydraulic jig cylinder must have sufficient stiffness, otherwise the hydraulic jig cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

hydraulic jig cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the hydraulic jig cylinder head itself is the guide sleeve of the piston rod, the hydraulic jig cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the hydraulic jig cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

The internal leakage of the hydraulic jig cylinder is an important indicator to measure the quality of the hydraulic jig cylinder: the internal leakage of the hydraulic jig cylinder will reduce the volumetric efficiency, increase the temperature rise of the oil, affect the positioning accuracy of the hydraulic jig cylinder, so that the hydraulic jig cylinder can not accurately and stably stop in a certain position of the hydraulic jig cylinder, so it is one of the main indicators of the hydraulic jig cylinder.

Answers to some questions about hydraulic jig cylinder:

Cylinder pressure calculation formula
The pressure of the cylinder at work is determined by the load, and the pressure of the physical force is equal to the force divided by the area of action (that is, P=F/S). If you want to calculate the output force of the cylinder, you can calculate it according to the formula: Set the radius of the piston (that is, the cylinder) is R (unit mm) the radius of the piston rod is r (unit mm) the working pressure P (unit MPa) the thrust of the cylinder F push =3.14*R*R*P (unit N) The pulling force of the cylinder F pull =3.14* (R*R-r* R) *P (unit N).

How to limit cylinder push rod rotation?
In general, the push-rod rotation can be limited after the push-rod is connected to the pushed mechanism. For example, the push rod is hinged with the push mechanism, or the push mechanism itself is guided, which can limit the rotation of the push rod.