This article mainly introduces:

Peru hydraulic cylinder,stern plate hydraulic cylinder manufacturer,stern plate hydraulic cylinder

(Peru stern plate hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

stern plate hydraulic cylinder are widely used in Peru，because of excellent temperature resistance，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed stern plate hydraulic cylinder for customers from Peru.

Introduction to stern plate hydraulic cylinder:

The internal leakage of the stern plate hydraulic cylinder should be prevented when the stern plate hydraulic cylinder is used. The internal leakage of stern plate hydraulic cylinder includes the leakage caused by excessive wear of stern plate hydraulic cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.

The stern plate hydraulic cylinder should be avoided for a long time without use, if it is indeed idle for a long time for some reason, it should also be regularly turned on for empty operation, so that its parts can be fully lubricated, so as to avoid rust on the working surface and affect the normal work in the future. (If it cannot be turned on and run, a small amount of lubricating oil can be applied on its outer surface for protection) ' The use of the stern plate hydraulic cylinder should pay attention to: the operation should be as far away from the stern plate hydraulic cylinder as possible, to avoid falling objects, knocking, rubbing the stern plate hydraulic cylinder coating. When cleaning the stern plate hydraulic cylinder, only use soft materials (such as cotton) to wipe, and do not scratch high-hardness materials. Do not use the stern plate hydraulic cylinder when the oil temperature exceeds 70 ° C.

The viscosity of the working oil used in the stern plate hydraulic cylinder is 29~74mm2/S, and ISO VG46 anti-wear hydraulic oil is recommended. Working oil temperature within the range of -20~80. C. When the ambient temperature and service temperature are low, the oil with lower viscosity can be selected.

stern plate hydraulic cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the stern plate hydraulic cylinder head itself is the guide sleeve of the piston rod, the stern plate hydraulic cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the stern plate hydraulic cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

Answers to some questions about stern plate hydraulic cylinder:

What is the material of the cylinder support ring?
Generally, it is polytetrafluoroethylene doped with copper powder, or polyformaldehyde, and copper sleeves, there are also nylon, resin and so on.

Where is the cylinder used? What is it used for? Can it be used in cars?
Cylinders can be used as actuator in hydraulic system. Such as hydraulic jacks, dump truck box lifting device, dodging (snow) machine loader bucket lifting device. Hydraulic cylinders are also widely used in car cranes. It's all about cars.