This article mainly introduces:

Cote d 'Ivoire hydraulic cylinder,swager cylinder manufacturer,swager cylinder

(Cote d 'Ivoire swager cylinder,produced by Hengyu Hydraulic Cylinder Factory）

swager cylinder are widely used in Cote d 'Ivoire，because of long service life，smooth movement，high work efficiency.So our company has designed swager cylinder for customers from Cote d 'Ivoire.

Introduction to swager cylinder:

When the swager cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the swager cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

swager cylinder to reasonable use of hydraulic oil: strict hydraulic oil selection off. Hydraulic oil is selected in strict accordance with oil standards. The selection of good quality hydraulic oil can effectively prevent bubbles in the working process of the hydraulic system. When choosing the oil, it should be selected according to the lowest temperature in different regions, and fill the hydraulic oil according to the dipstick standard, and at the same time, it should also keep the hydraulic system clean (when filling the hydraulic oil, it should prevent the water and other impurities into it), and often check the oil quality, oil level and oil color of the hydraulic oil. If blisters and bubbles are found in the hydraulic oil. When the oil becomes milky white, the source of the air in the oil should be carefully found and eliminated in time.

When the swager cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the swager cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

The daily inspection of the swager cylinder includes: checking the connection of the swager cylinder and the pipe joint for leaks. Check the swager cylinder rod for leaks. Check the swager cylinder connection for leaks. When the swager cylinder moves, the work is normal and smooth. Whether the swager cylinder has internal leakage.

Answers to some questions about swager cylinder:

Does the excavator use a hydraulic cylinder?
First, construction machinery is generally a hydraulic cylinder. Second, hydraulic transmission equipment is usually composed of four components, power, execution, control and auxiliary. And the hydraulic cylinder as a linear reciprocating motion or less than 360. Reciprocating motion of the hydraulic mechanism, simple structure, reliable work, is also widely used in the hydraulic system of the main actuator, it is the prime mover in the form of mechanical energy to drive the hydraulic pump produced by the liquid pressure energy, and then can be directly driven load for reciprocating movement or less than 360.

What welding rod is used for hydraulic cylinder welding?
There are several reasons for bad welding of hydraulic cylinder: 1. There is hydraulic oil on the welding surface, wipe it with a rag, there will be bubbles in the welding process, and it will not last for a few days. You have to remove it, drain it, wash it off with gasoline and try again. 2. Open the groove before welding, it is not deep enough to use the Angle grinding machine, and can not find the accurate crack position. 3. The material of the cylinder itself is not clear, the welding performance of more than 35 steel is not good, in the factory welding needs to preheat, the welding rod should also be dried and insulated, there is no such condition on the site.