This article mainly introduces:

Tunisia hydraulic cylinder,disc spring hydraulic cylinder manufacturer,disc spring hydraulic cylinder

(Tunisia disc spring hydraulic cylinder,produced by Hebei Hengyu company）

disc spring hydraulic cylinder are widely used in Tunisia，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed disc spring hydraulic cylinder for customers from Tunisia.

Introduction to disc spring hydraulic cylinder:

disc spring hydraulic cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the disc spring hydraulic cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the disc spring hydraulic cylinder. c. The disc spring hydraulic cylinder seal is extruded, if the O-ring is obviously extruded at the disc spring hydraulic cylinder seal, replace the disc spring hydraulic cylinder seal.

Do not enter foreign bodies when installing the disc spring hydraulic cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

When the disc spring hydraulic cylinder is kept, do not pay attention to keeping the oil port open, which will produce the condition of accepting foreign bodies at all times, which is absolutely not allowed. Storage must be filled with anti-rust oil or working oil, and plug.

If the seal of the disc spring hydraulic cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

Answers to some questions about disc spring hydraulic cylinder:

What is the material of the lift cylinder?
The cylinder is composed of many parts. The cylinder also contains the seal and the installation port at both ends, the material of these two parts is not easy to determine if there is no physical object. The cylinder body is generally 20 steel, 45 steel, 27SiMn and other materials, and the piston rod is generally 40Cr, 45 steel and other materials.

Hydraulic cylinder performance requirements?
Hydraulic cylinder performance requirements: hydraulic cylinder is the hydraulic system to achieve energy transfer, conversion and control of the working medium, in addition, it is also responsible for the lubrication of the system, rust prevention, corrosion prevention and cooling. The performance of hydraulic oil will make the system flexible, accurate and reliable. Hydraulic performance requirements are determined according to the design parameters of the hydraulic system, operating conditions, the structure of the hydraulic pump and the working environment. Appropriate viscosity and good viscosion-temperature performance Viscosity is an important performance indicator of hydraulic pressure, which has an important impact on the smooth operation of the hydraulic system and the friction parts. The low temperature performance of hydraulic oil includes three aspects: low temperature flow, low temperature start-up and low temperature pumping.