This article mainly introduces:

Bahrain hydraulic cylinder,tension cylinder manufacturer,tension cylinder

(Bahrain tension cylinder,produced by Hebei Hengyu company）

tension cylinder are widely used in Bahrain，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed tension cylinder for customers from Bahrain.

Introduction to tension cylinder:

The tension cylinder should be used correctly and maintained regularly. The tension cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the tension cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

If the piston rod and tension cylinder are stuck or the tension cylinder is blocked, at this time, no matter how to operate, the tension cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the tension cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

The difference between the plunger tension cylinder and the piston tension cylinder is that the piston in the tension cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type tension cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

Under normal circumstances, the tension cylinder is composed of the rear end cover, body, piston, piston rod and front end cover and other main parts. In order to prevent the working medium from leaking out of the tension cylinder or from the high pressure chamber to the low pressure chamber, a sealing device (sealing ring) is arranged between the tension cylinder and the end cover, the piston and the piston rod, the piston and the tension cylinder, the piston rod and the front end cover. A dustproof device is also provided on the outside of the front end cover. In order to prevent the piston from impacting the end cap when it moves rapidly to the end of the stroke, the end of the tension cylinder can also be provided with a buffer device. If necessary, the exhaust device should be set in order to exhaust.

Answers to some questions about tension cylinder:

When the superimposed hydraulic control valve is added to the bottom of a solenoid valve and a double directional throttle valve, why does the cylinder shock on the return trip?
The stack hydraulic control check valve must be added above the stack one-way throttle valve.

What is the difference between hydraulic cylinder self-adjusting buffer and adjustable buffer?
If it is the buffer device inside the cylinder, then there are 4 basic forms, cylindrical buffer device, conical buffer device, variable throttle and adjustable flow groove. The biggest difference between the first three and the latter is that the latter can be adjusted through the external thimble to change the buffer strength, the first three mainly rely on the buffer device and buffer groove form to achieve the buffer (among them, the first type of buffer strength will not change, and the buffer strength of the two and three forms of buffer devices can be gradually increased).