This article mainly introduces:

Peru hydraulic cylinder,tailplate hydraulic cylinder manufacturer,tailplate hydraulic cylinder

(Peru tailplate hydraulic cylinder,produced by Hebei Hengyu company）

tailplate hydraulic cylinder are widely used in Peru，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed tailplate hydraulic cylinder for customers from Peru.

Introduction to tailplate hydraulic cylinder:

When the tailplate hydraulic cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the tailplate hydraulic cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

tailplate hydraulic cylinder and hydraulic station selection: Select the type and structure of the tailplate hydraulic cylinder according to the operation requirements of the main engine. According to the external load force borne by the tailplate hydraulic cylinder, such as gravity, friction force of the external mechanism, inertia force and working load, determine the load change law of the tailplate hydraulic cylinder in each stage of the stroke and the power value that must be provided. Determine the diameter of the piston and piston rod according to the working load of the tailplate hydraulic cylinder and the selected oil working pressure. the flow rate of the hydraulic pump is determined according to the movement speed of the tailplate hydraulic cylinder, the diameter of the piston and the piston rod.

When the tailplate hydraulic cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the tailplate hydraulic cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil tailplate hydraulic cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical tailplate hydraulic cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the tailplate hydraulic cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

The tailplate hydraulic cylinder is not the same as the tailplate hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the tailplate hydraulic cylinder can not be used as a high-power power component, but the tailplate hydraulic cylinder can be used as a relatively large power component, or the tailplate hydraulic cylinder system can be used.

Answers to some questions about tailplate hydraulic cylinder:

Does the excavator use a hydraulic cylinder?
First, construction machinery is generally a hydraulic cylinder. Second, hydraulic transmission equipment is usually composed of four components, power, execution, control and auxiliary. And the hydraulic cylinder as a linear reciprocating motion or less than 360. Reciprocating motion of the hydraulic mechanism, simple structure, reliable work, is also widely used in the hydraulic system of the main actuator, it is the prime mover in the form of mechanical energy to drive the hydraulic pump produced by the liquid pressure energy, and then can be directly driven load for reciprocating movement or less than 360.

What is the safety factor of 25MPa cylinder wall thickness?
Safety factor n can take 3 cylinder material allowable stress [s]=sb/n δ/D=0.08 ~ 0.3 cylinder wall thickness δ=PMAX*D/ (2.3[s]-3PMAX) δ/D≤0.08 cylinder wall thickness δ=PMAX*D/2[s] P < 16MPa, Pmax=1.5Pn; P > 16MPa, Pmax=1.25Pn cold-drawn tube or honing tube is better!