This article mainly introduces:

Malaysia hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder

(Malaysia shearing machine cylinder,produced by Hengyu Group）

shearing machine cylinder are widely used in Malaysia，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed shearing machine cylinder for customers from Malaysia.

Introduction to shearing machine cylinder:

The material, shape and compression of the shearing machine cylinder seal have a great impact on the service life and work efficiency of the shearing machine cylinder. In addition to requiring a reliable seal, it should also have a long service life and less friction loss. At present, there are many seal manufacturers in the country, and it is also crucial to choose high-quality seals with reliable and stable quality.

Most of the failure of the shearing machine cylinder is because there is a foreign body in the shearing machine cylinder into the failure of the shearing machine cylinder, the most problematic is that it is difficult to determine when the foreign body is into the shearing machine cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

When the long-stroke shearing machine cylinder rotates horizontally, the piston rod bends due to its own weight, causing the guide sleeve and piston to produce biased load, resulting in shearing machine cylinder head seal damage, oil leakage, and piston sleep in the shearing machine cylinder. The following measures can be taken: increase the piston plan to adjust the piston outer circle and process it into a convex drum, so that the piston can self-position, improve the force situation, and reduce and avoid pulling the shearing machine cylinder; The piston and the piston rod are connected with a spherical joint.

When the hydraulic oil is not pumped into the shearing machine cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the shearing machine cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

Answers to some questions about shearing machine cylinder:

What is the cylinder with rod cavity, what is the rodless cavity.
The rod cavity is the end of the piston rod, the rodless cavity is the end without the piston rod.

How to disassemble the big nut that excavate the oil cylinder piston of the excavator?
If you want to be safe, look for a special unloading place for this thing, which is an oil cylinder on top of a turntable with a large nut attached to the center of the turntable. If you're in the field just pin the head of the cylinder to one end, use a big homemade wrench to hold the nut in place, and then get a digging machine and push it down, and it opens.